MIC5213-3.6BC5 |
RFQ for MIC5213-3.6BC5 Required Field |
 |
| Product | Manufacturers | Pack | D/C |
| MIC5213-3.6BC5 | - | SC-70-5 | 05+ |
The MIC5213 is a µCap 80mA linear voltage regulator in the Teeny™ SC-70 package. Featuring half the footprint of the standard SOT-23 package, this Teeny SC-70 regulator has very low dropout voltage (typically 20mV at light loads and 300mV at 80mA) and very low ground current (225µA at 20mA output). It also offers better than 3% initial accuracy and includes a logic-compatible enable input.
The µCap regulator design is optimized to work with lowvalue, low-cost ceramic capacitors. The outputs typically require only 0.47µF of output capacitance for stability.Designed especially for hand-held, battery-powered devices, the MIC5213 can be controlled by a CMOS or TTL compatible logic signal. When disabled, power consumption drops nearly to zero. If on-off control is not required, the enable pin may be tied to the input for 3-terminal operation. The ground current of the MIC5213 increases only slightly in dropout, further prolonging battery life. Key MIC5213 features include current limiting, overtemperature shutdown, and protection against reversed battery.
The MIC5213 is available in 2.5V, 2.8V, 3.0V, 3.3V, and 3.6V fixed voltages. Other voltages are available; contact Micrel for details.
Typical Application |
Features |
| • Cellular telephones• Laptop, notebook, and palmtop computers• Battery-powered equipment• Bar code scanners• SMPS post-regulator/dc-to-dc modules• High-efficiency linear power supplies | •Teeny™SC-70 package•Wide Selection of output voltages•Guaranteed 80mA output•Low quiescent current•Low dropout voltage•Tight load and line regulation•Low temperature coefficient•Current and thermal limiting•Reversed input polarity protection•Zero off-mode current•Logic-controlled shutdown•Stability with low-ESR ceramic capacitors |
Input Supply Voltage (VIN) ............................ 20V to +20V
Enable Input Voltage (VEN) ........................... 20V to +20V
Power Dissipation (PD) ............................ Internally Limited
Storage Temperature Range (TS) ......... 60°C to +150°C
Lead Temperature (Soldering, 5 sec.) ...................... 260°C
Input Voltage (VIN) ........................................... 2.5V to 16V
Enable Input Voltage (VEN) .................................. 0V to VIN
Junction Temperature Range................ 40°C to +125°C
